If you are building a wall for a home addition, garage or other structure, it is important to be able to read construction drawings to identify all the dimensions for the walls which are given on the floor plan and elevation. The walls are to be laid out the same as on the floor plan, with all measurements followed exactly. The openings for doors and windows must be placed exactly. It is important that the corners be set on the foundation exactly as given on the detail drawing on the foundation plan. Taking measurements from the foundation or floor plan, and transferring those measurements to the foundation, footing or floor slab is the first step in laying out the wall.
Traditional stucco is made of lime, sand, and water. Modern stucco is made of Portland cement, sand, and water. Lime is added to increase the permeability and workability of modern stucco. Sometimes additives such as acrylics and glass fibers are added to improve the structural properties of the plaster. This is usually done with what is considered a one-coat stucco system, as opposed to the traditional three-coat method. As a building material, stucco is a durable, attractive, and weather-resistant wall covering. It was traditionally used as both an interior and exterior finish applied in one or two thin layers directly over a solid masonry, brick or stone surface. The finish coat usually contained an integral color and was typically textured for appearance.
There should be an access opening to all attic spaces that exceed 30 square feet and have a vertical height of 30 inches or more. The rough-framed opening should be at least 22 inches by 30 inches. It should be located in a hallway or other readily accessible location. An attic access that is located in a clothes closet is often inaccessible due to permanent shelving installed. There should be headroom that is a minimum of 30 inches above the attic access. In some places “attic” is used more specifically to apply to lofts which have boarded floors and ceilings, and usually windows or skylights, and then “loft” is kept to mean a dark, unboarded roof-space which lacks these features.
A plumbing fixture could refer to a receptacle or device that is either permanently or temporarily connected to the water distribution system of the property, and which demands a supply of water. Or the fixture could discharge waste water, liquid-suspended waste materials or sewage to the drainage system of the property. The fixture could also require both a water supply connection and a discharge to the drainage system of the property. Plumbing fixtures include water closets, urinals, bidets, lavatories, sinks, showers, bathtubs and floor drains.
Fully open the hot and cold water faucets and fill the whirlpool tub with water at least 1 to 3 inches above the whirlpool jets. Do not operate the pump until all jets are submerged. Direct the jets downward before activating the pump. Inspect the amount of bubbling with the controls. The suction inlets typically have very small openings, less than 1/8-inch in diameter, to prevent catching hair and pulling someone’s head under water.
The term “septic” refers to the anaerobic bacterial environment that develops in the tank and which decomposes or mineralizes the waste discharged into the tank. Septic tanks can be coupled with other on-site wastewater treatment units such as biofilters or aerobic systems involving artificial forced aeration.
The Barrie Home Inspections company provides visual and Thermal Imaging inspections of all major components of your home. A small investment considering the expense of buying property. Visit Barrie Home Inspector’s Site to arrange an inspection.
Want to find out more about the Innisfil Real Estate Agents, then visit www.innisfilrealestateagents.info/ site on how to choose the bestAngus Real Estate Agents for all your Angus Real Estate needs.